Pile Cut-off Level using Dynamo

If you are following my post, previously I looked at exporting the pile coordinates either from Survey Point or Project Base Point and explained in details where the results coming from with the help of diagrams. If you missed that section, you better go back to that article first before continue reading this one.

Here is the link for that article: Exporting Pile Coordinate from Survey Point instead of Project Base Point

Today, I want to give an update to my Dynamo script; to include in my final output the “Pile cut-off level” values for each individual piles on my project.

Here is the project that I’ll be looking at:

 

And I want to have the same result using the revised Dynamo script to one shown below.

Here is what the script looks like before from Exporting Pile Coordinate from Survey Point instead of Project Base Point:

And here is it now after the upgrade:

And the result when I “Run” the script and the comparison to Excitech Tools:

The first update I did was to extract the z-coordinates (Point.z node) and add 75mm (check this value with your structural engineer) for the “Embedment Length”, then round-up the result before converting the units from millimeters to meters. One thing that you need to make sure is that your pile is attached to the bottom of your pile cap. The 75mm embedment length calculation begins at the top most level of the pile.

Another update I did was to convert the result from “String.Remove” node to number using “String.ToNumber” node in order for me to convert the unit as well from millimeters to meters. As you may already know, the information provided by “String.Remove” node are considered as string and this is the reason why I need to convert it to number first in order for the “Divide” node to work.

And finally, add a new item, item4, from List.Create node to include the pile cut-off level.

Now I am ready to assign this values to my Northing, Easting and Pile Cut-off Level project parameters using my separate Dynamo script.

You can use this workflow if you don’t have Excitech Tools installed on your machine as part of your Revit Add-ins.

If you want to give it a try, here is the script.

Have a great day!

Cheers,

Allan Cantos EngTech MICE

BSc. Civil Engineering / Principal Structural Technician

Revit-Dynamo-Power BI Guide eBook on sale!

Click the image below to get your copy.

Any issues, errors or corrections, please give me a shout and I’ll sort it out quickly.

Happy reading and doing the exercises .

I trust you’ll find the tutorial helpful.

Best regards,

Allan Cantos EngTech MICE

BSc Civil Engineering / Principal Structural Technician